Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has been offering you issues, so you require to repair it. You can repair it by replacing a circuit board, a photo-eye sensor, the primary drive equipment, or the set-limit buttons. You can also check if the safety sensing units are working properly.

Changing a circuit card

Changing a circuit board for your garage door opener requires a few steps and also devices. First, you require to shut off the circuit breaker and detach any cables. Next, open the motherboard cover. This will certainly help you to diagnose the trouble as well as figure out if you require a new board. Next off, eliminate the old board as well as its cable ports.

You can then proceed to change the motherboard. The substitute procedure is simple as well as takes around 10 minutes. A brand-new circuit card will certainly cost concerning $80. To shield your new circuit board from power surges, you can purchase a rise protector.

Changing a photo-eye sensor

Replacing a photo-eye sensing unit can be a rather basic job. First, eliminate the sensing unit from the door as well as make sure it is positioned appropriately. If the sensing unit is angled by any means, it may not be obtaining the proper signal, which could be causing the strobe lights. If you discover that the photo-eyes run out placement, you may require to have actually a professional come and fix the problem.

The photo-eye sensing unit includes two pieces that place outside of the door tracks as well as towards the flooring. The image eyes will have a small LED light as well as should be solid in shade. If the light is blinking, its likely the photo-eye is malfunctioning and also will certainly require to be changed.

Changing a major drive gear

To change a garage door opener primary drive equipment, begin by removing the cap from the chain sheave. Next off, eliminate the two screws holding the drive equipment to the gear setting up. Now, you can loosen the three stress pins. Squeeze them from both sides and then eliminate them. Then, separate the three cables from the garage door opener electric motor. These wires need to be white, red, and also blue.

As soon as you have actually removed the old equipment, set up a brand-new one. Make sure to oil it well. Put the brand-new equipment right into the shaft, making sure to line up the installing openings. Make sure the equipment and also sprocket assembly are located properly to make sure smooth operation. Next, use a hammer and a nail to drive a pin right into the new gear.

Changing the set-limit buttons

The first thing you should do if your garage door is not working correctly is to inspect the set-limit buttons. You might require to readjust them so that the door shuts earlier or stops prior to it reaches the floor. You can inspect this by looking at your garage doors guidebook or online.

To adjust the set-limit buttons, youll need a screwdriver or socket. Readjust the handle clockwise or counterclockwise up until the door goes up as well as quits, or minimizes its range. To check for appropriate travel distance, measure the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

One thought on “Veteran Garage Door Repair | Keller TX | 817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top